• Pitagora 4.0 – Importing & Exporting Motherboard Configuration

    What you need Preliminary steps 1) Only if the files have already been copied to the USB drive 2) With the elevator stopped, open the safety chains by deactivating the “-DIS” switch. 3) Remove the connectors cover by unscrewing the fastening screws. Insert the USB flash drive and access the…

  • Pitagora 4.0 – Other Boards

    16 Relays control board The 16RL board is used to interface the DMG controller with non-serial devices/products.These devices may include:• 1 wire per floor position indicator• Gray code indicator• 9-segment indicator• 1 wire per floor HYD (for managing hydraulic power units)• Present signal• Floor lighting The display normally shows the…

  • Matisse Mirage

    (v 1.0) Safety and usage cautions Before installing our products, we recommend you to consult the section about safety and usage cautions at the link below System overview Matisse Mirage is a DMG application that combines technology with refined aesthetics. The MIRAGE function, integrated with the Matisse system, introduces a…

  • Amigo 2G/4G

    (v 1.0) Safety and usage cautions Before installing our products, we recommend you to consult the section about safety and usage cautions at the link below Introduction Thank you for your confidence in purchasing a DMG branded product. Amigo GSM 2G/4G (cod.: ETSGSM.4G) simulates an analog line where the traditional…

  • Prophesix

    (v 1.0) Safety and usage cautions Before installing our products, we recommend you to consult the section about safety and usage cautions at the link below Disposal and Recycling Information The crossed-out wheeled bin symbol shown on the product, battery, documentation or packaging indicates that batteries and electronic products must…

  • Raffaello M-One

    (v 1.0) Raffaello + MosaicONE Raffaello is DMG’s 65,000 color TFT display, now available with various graphic templates that can be customized directly from the MosaicONE platform.Its various sizes can cover multiple widths of fixtures: Raffaello 2″Raffaello 2,8″Raffaello 4,3″Raffaello 5″ Mounting Wiring Basic Wiring (Raffaello 2″) Basic Wiring (Raffaello 2,8″)…

  • Pitagora 4.0 – Fine-tuning of the system

    Once the floor self-learning procedure has been completed and the lift has been set to normal service mode, it is possible to manually adjust the floor stopping accuracy. Two different procedures are available, depending on the type of counting system.1) Magnetic readers counting system2) DMG incremental encoder / Motor encoder…

  • Pitagora 4.0 – Switch to NORMAL service mode

    1) Switch the system into NORMAL service mode Main Menu > Emulation > Configuration > Temporary operations > NO 2) System reset The LED 7 is OFF – There are no active faults.The cabin moves to the lowest floor for a system reset. The red LED 7 is flashing –…

  • Pitagora 4.0 – Motor Data self-learning procedure

    1) Switch the lift into INSPECTION mode 2) Motor Parameter check From the main menu, access the Emulation menu. Main Menu > Emulation > VVVF Advanced GEARED motors Parameters normally pre-set if specified when ordering. VVVF Fuji parameter Description Note P01 – Motor poles Enter the number of motor poles…

  • Sense

    (v 1.0) Safety and usage cautions Before installing our products, we recommend you to consult the section about safety and usage cautions at the link below Installation introduction Remove the break-off section from the plastic frame before starting installation. DOOR FRAME Mounting Flush installation Installation Kit Cut-out 1) Self-tapping screw…

dido.dmg.it
Learn more

Cookies Policy