(v 1.2)
To check and download all versions of this guide, go at the following link.
Safety and usage cautions
Before installing our products, we recommend you to consult the section about safety and usage cautions at the link below
B7 Maxxi Q – Square shape
Cut-out
Mounting
A) – Faceplate
B) – Wiring
Dismantling
Mounting of B7 IP54 version, EN81-71 class 1
A) – Faceplate
B) – O-Ring
M) – Screw terminal version (back view)
P) – Prewired version (back view)
Main floor button
A) – Faceplate
B) – O-Ring
C) – Main floor bezel
B7 Maxxi S – Round shape
Cut-out (back mounting)
Studs M3x20
Cut-out (frontal mounting)
Note: There are 4 anti-rotation points
Assembling (Back mounting)
This spacer indicates the thickness of the plate on which it will be mounted:
• One side for plate thicknesses of 1.5 mm and 2 mm
• The other side for plate thickness of 3 mm
• The spacer must not be used with the main floor button.
Assembling (Frontal mounting)
A) Present ONLY with the main floor push-button.
Wirings
Screw terminal version
C1) First contact
C2) Second contact (e.g.: Alarm button)
JST connector version for Pitagora 4.0 prewiring – Call butttons
C1) 4-pin JST connector for connection to the DMCPIT board in the cabin.
JST connector version for Pitagora 4.0 prewiring – Alarm buttton
B) 2-pin JST connector for backlight connection to the DMCPIT board (2-pin AMP connector) in the cabin
C1) 4-pin JST connector for connection to the DMCPIT board in the cabin.
C2) 3-pin JST connector (dry contact) for connection to third-party telephony systems.
Download
| Reference | Version | Link |
|---|---|---|
| 1.0 | Download PDF (English) | |
| Main floor version | 1.1 | Download PDF (English) |
| Round version | 1.2 (current version) |