1. Home
  2. Components
  3. Predisposition for Eurocylinder key

Predisposition for Eurocylinder key

(v 1.4)

To check and download all versions of this guide, go at the following link.

Safety and usage cautions

Before installing our products, we recommend you to consult the section about safety and usage cautions at the link below

Mounting of services key (variant 1/2/3/4)

Plate mounted component

[ 1 ] – Remove the locking screw.
[ 2 ] – Insert the cylinder.

[ 3 ] – Insert the locking screw.
[ 4 ] – Remove the security lock.

Spare component (not plate mounted)

[ 1 ] – Disassemble the components.
Attention: don’t remove now the security lock.

[ 2 ] – Assemble the components to the plate as shown in the picture.

Be careful to the spacer alignment.

[ 3 ] – Insert the cylinder.
[ 4 ] – Insert the locking screw.
[ 5 ] – Remove the security lock.

Mounting of calls key (variant 5)

Plate mounted component

[ 1 ] – Insert the cylinder.
[ 2 ] – Insert the locking screw.

[ 3 ] – Remove the security lock.

Spare component (not plate mounted)

[ 1 ] – Disassemble the components.
Attention: don’t remove now the security lock.

[ 2 ] – Assemble the components to the plate as shown in the picture.
A) – Aesthetic plate
B) – Cut-out
C) – Spacer
D) – Flush version only

[ 3 ] – Insert the cylinder.
[ 4 ] – Insert the locking screw.
[ 5 ] – Remove the security lock.

Cylinder replacement

[ 1 ] – Remove the locking screw.
[ 2 ] – Gently turn the key in the sense of activation and pull out the cylinder about 5mm until it stops.
[ 3 ] – Release the key to position 0, then completely pull out the cylinder.

[ 4 ] – Using a screwdriver, restore the spring in the correct position (A+B) and simultaneously insert the spring security lock (C) or any 2mm diameter cylindrical element.
Now you can insert the new cylinder.

Download

ReferenceVersionLink
1.4 (current version)Download PDF
(English)
Updated on 28 Ottobre 2021

Was this article helpful?

Related Articles